You’ve brought your generator out of storage,filled the tank,pulled the cord,and absolutely nothing. Before trying any repair work,get rid of the spark plug to prevent unintentional starting while you are working on the unit.

If the generator will not start or will not stay running,inspect the muffler exhaust for an foreign particles. As soon as that is clean,inspect the gas and oil to make certain you have proper levels of both. Finally,make certain the spark plug has an excellent connection.

It might be running at too low of a speed if the generator does not generate electricity. Change the rpm. This can also result from a defective capacitor or windings,which must be changed and tightened up.

You might need to adjust the rpms to a lower speed or change the capacitor if the voltage is running high with no load on the generator. On the other hand,if the voltage is running low under no load,you might need to adjust the rpms to a greater speed or change the capacitor with one with a greater ranking. In addition,for low voltage,you must inspect your winding resistance and change your rotary diodes,if needed.

If your voltage is okay with no load,but drops when you add a little load,you might need to increase your rpms or get rid of a few items of the load. You might also need to change your rotary diodes.

You probably need to adjust the rpms or get rid of some of the load if the voltage drops when you add a high load.

If the voltage changes,it might be the result of unclean or loose connections. You might also need to regulate the rpms to fix this problem. If all else fails call this company: El Dorado Hills electrical contractor Joe Eilhardt

Summarizing

If the voltage is running high with no load on the generator,you might need to adjust the rpms to a lower speed or change the capacitor. On the other hand,if the voltage is running low under no load,you might need to adjust the rpms to a greater speed or change the capacitor with one with a greater ranking. In addition,for low voltage,you must inspect your winding resistance and change your rotary diodes,if needed.